JIS B 0025:1998
JIS B 0025:1998
Technical drawings - Geometrical tolerancing - Positional tolerancing
Japanese Standards Association
Specials
-
-
SAE J 2384 : 2012
$78.00 (-56%) $34.32
Table of Contents
Abstract
This Standard describes the principle of positional tolerancing for the location of regular and irregular features. However for clarity, only regular-shaped features such as holes, bolts, studs or pins, parallel-sided slots, key and keyways have been shown. Positional tolerancing may also be applied to the location of a point, a straight line, or a plane surface. However, profile tolerancing must be used when lines are not intended to be straight or surfaces are not intended to lie in a plane, see ISO 1660:1987.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Japanese Standards Association |
