JIS R 6211-4:2014

Table of Contents

Introduction
1 Scope
2 Normative references
3 Dimensions
3.1 Type 1: Straight grinding wheel
3.2 Type 5: Wheel recessed on one side
3.3 Type 7: Wheel recessed on both side
3.4 Type 20: Wheel relieved on one side
3.5 Type 21: Wheel relieved on both side
3.6 Type 22: Wheel relieved on one side and recessed on
the other side
3.7 Type 23: Wheel relieved and recessed on one side
3.8 Type 24: Wheel relieved and recessed on one side and
recessed on the other side
3.9 Type 25: Wheel relieved and recessed on one side and
relived on the other side
3.10 Type 26: Wheel relieved and recessed on both side
3.11 Type 38: Hubbed Wheel and Type 39: Double hubbed wheel
4 Designation
Annex (informative) Comparison table between JIS and corresponding
International Standard

Abstract

Describes the nominal dimensions of grinding wheels for surface grinding/peripheral grinding of: Type 1: Straight grinding wheel; Type 5: Wheel recessed on one side; Type 7: Wheel recessed on both sides; Type 20: Wheel relieved on one side; Type 21: Wheel relieved on both sides; Type 22: Wheel relieved on one side and recessed on the other side; Type 23: Wheel relieved and recessed on one side; Type 24: Wheel relieved and recessed on one side and recessed on the other side; Type 25: Wheel relieved and recessed on one side and relieved on the other side; Type 26: Wheel relieved and recessed on both sides; Type 38: Hubbed wheel; Type 39: Double hubbed wheel.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Japanese Standards Association
ProductNote	Supersedes JIS R6211 (04/2003)
Pages
ISBN
Supersedes	JIS R 6211-4:2003 JIS R 6211:1986