API 17E REDLINE : 2010

Table of Contents

API Foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, abbreviated terms and definitions
4 Functional requirements
5 Safety, design and testing philosophy
6 Design requirements
7 Component design, manufacture and test
8 Terminations and ancillary equipment design
9 Umbilical design
10 Umbilical manufacture and test
11 Factory acceptance tests
12 Storage
13 Pre-installation activity
14 Load-out
15 Installation operations
Annex A (informative) - Information that should be
        provided in a purchaser's functional
        specification
Annex B (informative) - Umbilical testing
Annex C (informative) - Hose and tube preferred
        sizes
Annex D (normative) - Characterization tests for
        hoses and umbilicals
Annex E (informative) - Fatigue testing
Annex F (informative) - Load-effect analysis
Annex G (informative) - Umbilical full-scale tests
Annex H (informative) - Tube material matrix
Annex I (informative) - Tube-wall thickness example
        calculation
Annex J (informative) - Buckling of metallic tubes
Annex K (informative) - Use of the API Monogram
        Program by Licensees
Bibliography

Abstract

Describes requirements and gives recommendations for the design, material selection, manufacture, design verification, testing, installation and operation of umbilicals and associated ancillary equipment for the petroleum and natural gas industries.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	American Petroleum Institute
Pages
ISBN